infrared lamp for drying paint carbon fibre heating lamp

June 10, 2026

Why go for an infrared lamp when you need a serious cure?

Here’s the truth: we built these infrared halogen lamps for one reason—to deliver fast, focused heat that gets the job done on the factory floor. Whether you’re drying paint or curing carbon fiber parts, the goal stays the same. You want heat that goes straight to the part, not into warming up the air around it. That’s the kind of efficiency that keeps your line moving.

The power behind the punch

We engineered these lamps around one thing: power density. Take our 2500W lamp in a 300mm tube. It concentrates a lot of heat into a small footprint. That means you can run your line faster. But that kind of power comes with a catch—you need a solid electrical setup to back it up. We run these at 400V to keep the current manageable compared to lower voltage options. Just make sure your wiring and control gear can handle the load. And that compact 300mm length? It was designed for those tight spaces inside machines where every inch counts.

What’s inside that makes it work

Inside the quartz envelope, we use a halogen cycle to keep the light output steady over the lamp’s life. No more blackening that kills standard infrared tubes. You get a consistent heat profile, day after day. The shortwave infrared spectrum hits the sweet spot for paints and carbon fiber resins. It penetrates the surface, curing from the inside out. And the R7s connector? It’s a standard industrial fit that makes installation a simple slide-in. It’s built to handle the constant heating and cooling of a real production environment without letting you down.

What it feels like on the line

In the real world, this setup slides right in as a replacement for older heating systems in paint booths and composite curing ovens. The concentrated heat lets you cure parts faster, which boosts throughput. That’s the upside. But here’s the trade-off. That intense heat density means you need a properly matched cooling system in your machine. You have to manage the ambient temperature to protect sensitive components. We build these lamps to be the workhorses of the line. But you’ve got to pair that heat input with solid heat rejection. **The reality check:**A 400V, 2500W tube throws off serious heat. Your machine’s cooling system has to be up to the task.